7/8/2023 0 Comments Mark disk![]() ![]() ![]() If the partition was not formatted by using Windows, you might also need to run the Recovery Console fixboot command to make the active partition bootable.Īfter you can boot into Windows, it is recommended that you use the Windows Disk Management snap-in tool to reset the original system partition as the active partition, and then restart the computer. There is a space between the d and the two periods (.). Start your computer by using the Windows XP Setup floppy disks or by using the Windows XP CD-ROM.Īt the Welcome to Setup screen, press F10, or press R to repair.Ĭopy the Ntldr file from the Windows XP CD-ROM to the root of your system partition by using the following commands, pressing ENTER after each command: Using the Recovery Console, copy the Ntldr file from the Windows XP CD-ROM to the root directory of the current active partition. On Intel x86 computers, this is always drive 0, the drive that the system BIOS searches when the operating system starts. On Intel x86-based computers, the system partition must be a primary partition that is marked active. The system partition refers to the disk volume that contains the files that are needed to start Windows (for example, Ntldr, Boot.ini, and ). If the partition that has been incorrectly marked as active is formatted in the FAT file system, the FAT32 file system, or the NTFS file system, you may be able to use the Windows Recovery Console to correct the behavior.įor more information, see What are the system recovery options in Windows?. For more information, see Create a system repair disc. Remove the boot floppy disk, and then restart the computer.īoot the computer by using a Windows XP boot disk.Click Set active partition, press the number of the partition that you want to make active, and then press ENTER.When you are prompted to enable large disk support, click Yes.Crystal Disk Mark gip bn o hiu sut a nhanh v chnh xc. At the command prompt, type fdisk, and then press ENTER. CrystalDiskMark 8.0.4b l phn mm benchmark a n gin nhng hot ng cc k hiu qu. ![]() Boot to a command prompt by using a Microsoft Windows 95, Microsoft Windows 98, or Microsoft Windows Millennium Edition (Me) boot floppy disk.Try changing the active partition by booting to a floppy disk and then using disk utilities to manually change the active partition: To resolve this behavior, use one of the following procedures: Before performing the steps listed below, make sure that you have a good backup of your critical data files.
0 Comments
Leave a Reply. |